
12
ENGLISH
GB
the level comes below it (fig. 12).
SAFETY SYSTEM
This machine is equipped with a safety system that
consists of:
- a switch on the gearbox (only 2105M).
- a switch on the break pedal (only 2125H).
- a switch in the seat/seat bracket (all).
In order to start the machine, the following are nec-
essary:
- gear lever in neutral (only 2105M).
- brake pedal pressed down.
- driver sitting on seat.
- power take-off disengaged.
Always check the operation of the safe-
ty system before using the machine!
With the engine running and the driver sitting on
the seat, check as follows:
- select a gear, lift your weight off the seat – the
engine must stop (only 2105M).
- press the drive pedal so that the machine starts
to move, release the drive pedal – the machine
should stop (only 2125H).
- engage the power take-off, lift your weight off
the seat – the engine should stop.
Do not use the machine if the safety sys-
tem is not working! Take the machine
to a service workshop for inspection!
STARTING ENGINE
1. Open the fuel cock (fig. 11).
2. Make sure that the spark plug cable is properly
in place.
3. Check to make sure that the power take-off is
disengaged.
4a. 2105M: Put the gear lever in neutral.
4b. 2125H: Do not keep your foot on the drive ped-
al.
5. Starting cold engine – put the throttle control in
the choke position. Starting warm engine – put the
throttle control at full throttle (approx. 1 cm behind
the choke position).
6. Depress the brake pedal fully.
7. Turn the ignition key and start the engine.
8. Once the engine has started, move the throttle
control gradually to full throttle if the choke has
been used.
9. When starting from cold, do not make the ma-
chine work under load immediately, but let the en-
gine run for a few minutes first. This will allow the
oil to warm up.
When in use, always operate the engine at full
throttle.
STOPPING
Disengage the power take-off. Apply the parking
brake.
Allow the engine to idle 1 - 2 mins. Stop the engine
by turning off the starter key.
Shut off the petrol cock. This is particularly impor-
tant if the machine is to be transported on a trailer
for example.
If the machine is left unattended, re-
move the ignition key. Also remove the
spark plug cable from the spark plug.
The engine may be very warm immedi-
ately after it is shut off. Do not touch the
silencer, cylinder or cooling fins. This
can cause burn injuries.
DRIVING TIPS
Make sure that there is the correct quantity of oil in
the engine when driving on slopes (oil level on
“FULL”).
Be careful when driving on slopes. No
sudden starting or stopping when mov-
ing up or down a slope. Never drive
across a slope. Move from the top down,
and from the bottom to the top.
The machine, equipped with original
accessories, may not be driven on slopes
greater than 10º in any direction.
Reduce the speed on slopes and when
making sharp turns to prevent the ma-
chine from tipping over or you losing
control of the machine.
Do not turn the steering wheel to full
lock when driving in top gear and at full
throttle. The machine can easily topple
over.
Keep hands and fingers well away from
the seat bracket. Risk of crushing inju-
ries. Never drive with the engine hood
Kommentare zu diesen Handbüchern